Quantcast
Viewing all articles
Browse latest Browse all 13675

Moar Mold

Using Lavender Linda Lovelace's lower, we attacked the "why is the take-down so fucking tight?"

We sanded the top of the lower to make it all even, it didn't leave the mold flat.

Then we removed a lot more material in the radius from the top of the lower to the front of the receiver extension boss (see pointer).


Now the take down pin can be pushed in with finger pressure and pushed out if you have a tool to push on the recessed end, but you no longer need to tap it out with a hammer.

Viewing all articles
Browse latest Browse all 13675

Trending Articles